![]() The three-way speakers will probably have two tweeters and a low, or a tweeter, mid and a low. Basically, one signal wire is connected to the speaker right from the deck, and the speaker divides the frequency to the appropriate locations within itself. Co-ax speakers come in a variety of styles, usually two-way, three-way, or even four-way setups. There's more of a difference between component sets and co-ax speakers. You really dont need to amp the speakers then, I'm sure you'll be happy wiring those up to the high-levels outputs. It's not worth the extra money, and our Yotas have decent setups from the factory. ![]() ![]() This is just what I've learned over the years, and after many installs.įor what it's worth, if I wanted to leave the factory HU in place, I'd leave the factory speakers as well. This is all just my opinion, free advice is usually the price you pay. At least when you overpower a speaker, you can HEAR when you're damaging the speaker. This would happen if you used the factory unit. Some would argue that underpowering speakers (subs, components, all the like) is incredibly hard on them, especially at high volumes. If you wanna leave the factory unit, it probably wouldn't be a bad idea to amp the speakers, but doing that isn't common practice. They are usually adequate to power modest coax speakers or components. Even the worst and cheapest decks nowadays put out more power then most factory units. You COULD amp the new speakers, but most people just buy a better deck. Technically, the dude at BestBuy is right, however, if you have a stock head unit, your new speakers probably wont sound all that better.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |